crimson restaurant menu
Atoto Steering Wheel Control # + to Toyota PURPLE AND WHITE (middle one) - with 300 ohm resistor; Atoto BLACK GROUND to Toyota White/Red stripe; Atoto Steering Wheel Key + to Toyota Yellow/Black line - with 2000 ohm resistor. Note: You must place two resistors inline (in series) with the #+ and the + wires. These are absolutely necessary. Ok guys I'm sorta at a loss here and need some help. I just installed an Atoto S8 Premium 10.1" into my 2013 gen3. When I first wired it up everything worked perfect. I ran SW1 and SW2 wires from the 28 pin to my steering wheel control wires and grounded the SWC wire. I can say that the Pac RP4-CH11 and this Atoto S8 seem to be a good match so far. Simple to connect to the radio harness and ALL steering wheel controls work. Including mapping the VR button to the Google Voice Assistant ("ok google") and the Phone button to the phone button of the radio to answer or hang up calls.